1. Adjust the transmission chain of the motorcycle. First use the main bracket to support the bike, and then loosen the screws of the rear axle. Some bikes also have a large nut on the flat fork on one side of the axle. In this case, the nut must also be tightened. loose. Then turn the chain adjusters on the left and right sides behind the rear flat fork to adjust the chain tension to a suitable range. Generally, the lower half of the chain can float up and down between 20-30 mm, and pay attention to the scales of the left and right chain adjusters being consistent. It is best to tighten each loosened screw and lubricate it appropriately depending on the chain condition.
2. If you want to clean the chain, first spray the chain cleaner on the motorcycle chain. This will allow the chain to be in more comprehensive contact with the cleaner, and some dirt that is particularly difficult to clean can be dissolved.
3. After handling the chain, you need to clean the entire motorcycle a little and remove the dust on the surface to prevent the chain from getting dirty again after being installed. After all this is done, you only need to apply lubricant to the chain again, so that the chain will be clean and smooth. If you want your motorcycle to look tidier, daily care is also important.
Post time: Jan-29-2024