News

  • What should I do if the motorcycle engine chain is loose?

    What should I do if the motorcycle engine chain is loose?

    The small motorcycle engine chain is loose and must be replaced. This small chain is automatically tensioned and cannot be repaired. The specific steps are as follows: 1. Remove the left wind panel of the motorcycle. 2. Remove the front and rear timing covers of the engine. 3. Remove the engine c...
    Read more
  • Can the dolphin belt be replaced with a chain?

    Can the dolphin belt be replaced with a chain?

    A dolphin’s leash cannot be turned into a chain. Reason: Chains are mainly divided into two types: sleeve roller chains and toothed chains. Among them, the roller chain is affected by its innate structure, so the rotation noise is more obvious than that of the synchronous belt, and the tran...
    Read more
  • What is the difference between silent chain and toothed chain?

    What is the difference between silent chain and toothed chain?

    Toothed chain, also known as Silent Chain, is a form of transmission chain. my country’s national standard is: GB/T10855-2003 “Toothed Chains and Sprockets”. The tooth chain is composed of a series of tooth chain plates and guide plates that are assembled alternately and connect...
    Read more
  • How does a chain work?

    How does a chain work?

    The chain is a common transmission device. The working principle of the chain is to reduce the friction between the chain and the sprocket through the double curved chain, thereby reducing the energy loss during power transmission, thereby obtaining higher transmission efficiency. The application...
    Read more
  • How to wash off bicycle chain oil from clothes

    How to wash off bicycle chain oil from clothes

    To clean grease from your clothes and bike chains, try the following: To clean oil stains from clothes: 1. Quick treatment: First, gently wipe off excess oil stains on the surface of the clothing with a paper towel or rag to prevent further penetration and spread. 2. Pre-treatment: Apply an appro...
    Read more
  • What to do if the bicycle chain keeps falling off

    What to do if the bicycle chain keeps falling off

    There are many possibilities for a bicycle chain that keeps falling off. Here are some ways to deal with it: 1. Adjust the derailleur: If the bicycle is equipped with a derailleur, it may be that the derailleur is not adjusted properly, causing the chain to fall off. This can be solved by adjusti...
    Read more
  • Agents of bullead chain participated in the exhibition

    Read more
  • What to do if the bicycle chain slips?

    What to do if the bicycle chain slips?

    Bicycle chain slipping teeth can be treated by the following methods: 1. Adjust the transmission: First check whether the transmission is adjusted correctly. If the transmission is improperly adjusted, it may cause excessive friction between the chain and the gears, causing tooth slipping. You ca...
    Read more
  • How to prevent the mountain bike chain from rubbing against the derailleur?

    How to prevent the mountain bike chain from rubbing against the derailleur?

    There are two screws on the front transmission, marked “H” and “L” next to them, which limit the range of movement of the transmission. Among them, “H” refers to high speed, which is the large cap, and “L” refers to low speed, which is the small cap...
    Read more
  • How to tighten the chain of a variable speed bicycle?

    How to tighten the chain of a variable speed bicycle?

    You can adjust the rear wheel derailleur until the rear small wheel screw is tightened to tighten the chain. The tightness of the bicycle chain is generally no less than two centimeters up and down. Turn the bicycle over and put it away; then use a wrench to loosen the nuts at both ends of the r...
    Read more
  • There is friction between the front derailleur of the bicycle and the chain. How should I adjust it?

    There is friction between the front derailleur of the bicycle and the chain. How should I adjust it?

    Adjust the front derailleur. There are two screws on the front derailleur. One is marked “H” and the other is marked “L”. If the large chainring is not ground but the middle chainring is, you can fine-tune L so that The front derailleur is closer to the calibration chainri...
    Read more
  • Will the motorcycle chain break if not maintained?

    Will the motorcycle chain break if not maintained?

    It will break if not maintained. If the motorcycle chain is not maintained for a long time, it will rust due to lack of oil and water, resulting in the inability to fully engage with the motorcycle chain plate, which will cause the chain to age, break, and fall off. If the chain is too loose, the...
    Read more