News
-
Why should chain drive chains be tightened and loosened?
The operation of the chain is the cooperation of many aspects to achieve working kinetic energy. Too much or too little tension will cause it to produce excessive noise. So how do we adjust the tensioning device to achieve reasonable tightness? The tensioning of the chain drive has obvious effect...Read more -
What is the difference between half buckle and full buckle chain?
There is only one difference, the number of sections is different. The full buckle of the chain has an even number of sections, while the half buckle has an odd number of sections. For example, section 233 requires a full buckle, while section 232 requires a half buckle. The chain is a kind of ch...Read more -
The chain of the mountain bike cannot be reversed and gets stuck as soon as it is reversed
The possible reasons why the mountain bike chain cannot be reversed and gets stuck are as follows: 1. The derailleur is not adjusted properly: During riding, the chain and derailleur are constantly rubbing. Over time, the derailleur may become loose or misaligned, causing the chain to get stuck. ...Read more -
Why does the bicycle chain keep slipping?
When a bicycle is used for a long time, the teeth will slip. This is caused by the wear of one end of the chain hole. You can open the joint, turn it around, and change the inner ring of the chain into an outer ring. The damaged side will not be in direct contact with the large and small gears. ,...Read more -
What oil is best for mountain bike chains?
1. Which bicycle chain oil to choose: If you have a small budget, choose mineral oil, but its lifespan is definitely longer than that of synthetic oil. If you look at the overall cost, including preventing chain corrosion and rust, and re-adding man-hours, then it is definitely cheaper to buy syn...Read more -
What to do if the metal chain is rusty
1. Clean with vinegar 1. Add 1 cup (240 ml) white vinegar to the bowl White vinegar is a natural cleaner that is slightly acidic but will not cause harm to the necklace. Pour some into a bowl or shallow dish large enough to hold your necklace. You can find white vinegar at most household or groce...Read more -
How to clean rusty chain
1. Remove original oil stains, clean soil and other impurities. You can directly put it into water to clean the soil, and use tweezers to clearly see the impurities. 2. After simple cleaning, use a professional degreaser to remove the oil stains in the slits and wipe them clean. 3. Use profession...Read more -
How often should a motorcycle chain be replaced?
How to replace a motorcycle chain: 1. The chain is excessively worn and the distance between the two teeth is not within the normal size range, so it should be replaced; 2. If many sections of the chain have been seriously damaged and cannot be partially repaired, the chain should be replaced wit...Read more -
How to maintain bicycle chain?
Choose a bicycle chain oil. Bicycle chains basically do not use engine oil used in automobiles and motorcycles, sewing machine oil, etc. This is mainly because these oils have limited lubrication effect on the chain and are highly viscous. They can easily stick to a lot of sediment or even splash...Read more -
How to clean bicycle chain
Bicycle chains can be cleaned using diesel fuel. Prepare an appropriate amount of diesel and a rag, then prop up the bicycle first, that is, put the bicycle on the maintenance stand, change the chainring to a medium or small chainring, and change the flywheel to the middle gear. Adjust the bike s...Read more -
How to judge whether there is a problem with the motorcycle chain
If there is a problem with the motorcycle chain, the most obvious symptom is abnormal noise. The motorcycle small chain is an automatic tensioning working regular chain. Due to the use of torque, the small chain lengthening is the most common problem. After reaching a certain length, the automati...Read more -
How to look at the motorcycle chain model
Question 1: How do you know what model the motorcycle chain gear is? If it is a large transmission chain and large sprocket for motorcycles, there are only two common ones, 420 and 428. 420 is generally used in older models with small displacements and smaller bodies, such as the early 70s, 90s a...Read more
