How to check the tightness of a motorcycle chain: Use a screwdriver to pick up the middle part of the chain. If the jump is not large and the chain does not overlap, it means the tightness is appropriate. The tightness depends on the middle part of the chain when it is lifted.
Most straddle bikes these days are chain driven, and of course a few pedals are also chain driven. Compared with belt drive, chain drive has the advantages of reliable operation, high efficiency, large transmission power, etc., and can work in harsh environments. However, many riders criticize it for its easy elongation. The tightness of the chain will directly affect the driving of the vehicle.
Most models have chain instructions, and the upper and lower range is between 15-20 mm. The floating range of the chain is different for different models. Generally, off-road motorcycles are relatively large, and they need to be compressed by the long-stroke rear shock absorber to reach the normal range value.
Extended information:
The precautions for the use of motorcycle chains are as follows:
The new sling is too long or stretched after use, making it difficult to adjust. Links can be removed as appropriate, but must be an even number. The link should go through the back of the chain and the lock plate should go in on the outside. The opening direction of the lock plate should be opposite to the direction of rotation.
After the sprocket is severely worn, the new sprocket and the new chain should be replaced at the same time to ensure good meshing. A new chain or sprocket cannot be replaced alone. Otherwise, it will cause poor meshing and accelerate the wear of the new chain or sprocket. When the tooth surface of the sprocket is worn to a certain extent, it should be turned over and used in time (referring to the sprocket used on the adjustable surface). Extend use time.
Post time: Sep-02-2023